The attic area does have sufficient room for moderate storage or to access for the purpose of running wires and installing various ceiling fixtures.
Manufactured home with no attic.
Common mobile home insulation mistakes issues and problems missing insulation in the attic.
This is due to the fact that most mobile homes have very little space between the ceiling and roofing so the manufacturers figure why bother with it.
I feel that roof vents do a better job of removing moisture.
Most mobile homes do not have attic access.
Most older homes here only have static gable vents period.
A literature search and review was conducted to investigate attic ventilation design strategies for manufactured homes.
This problem can have a multitude of causes.
I am saying 2 powered fans because the two halves of the home s attic is divided by the marriage beam.
I own a 2005 double wide fleetwood mfg home with open beamed ceilings throughout.
These homes will tend to build up a lot of heat in the summer though.
I always assumed that there was no space between the ceiling beams and the roof however there is about a four foot high factory installed duct through the roof near the marriage line to the the ceiling in the living room for the evap.
Many mobile homes built before 1976 only have between 1 and 4 inches of poor quality insulation if they have any at all.
The findings of the literature review were debated among and analyzed by a steering committee of industry representatives.
Opening the ceiling to gain access is not a difficult process.
I do like roof vents better or maybe with gable vents.
Fortunately manufactured home builders have gotten a lot better after the hud code regulations began and of course there have been significant advances in mobile home insulation.
The manufactured home i beams are not removable the home is built to hud code.
Attic ventilation design strategies for manufactured homes.
Interestingly most manufactured homes do not come with an attic access for new homeowners.
A modular home will appraise very similar to a stick built and in some cases you will be unable to tell.
Manufactured houses do not usually have attic access because of the limited space between the ceiling and roof.
A manufactured home usually has 2 x 6 or 2 x 8 floor joist 16 on center 1 x 4 top and bottom plates on interior walls and no attic access.
Even if the insulation was installed many builders left voids and gaps throughout the home.
The important thing is that even a little bit of missing insulation can have a huge effect on its overall effectiveness.
You ll find one possibly two or even three features unique to modular home construction.